In-Vehicle Installation Guidelines for FOX3-2G/3G/4G and BOLERO40 Series
3
Revision History
Date
Rev.
Comments
July 2006
1.0.0
Initial version.
December 2006
1.0.1
Added all applicable devices
January 2007
1.0.2
Replaced Figure 3 by a new one. Added description below this
figure.
February 2007
1.0.3
Added point 12 in chapter Fehler: Verweis nicht gefunden -
devices are not protected against over-voltage.
November 2007
1.0.4
Added additional information about usage of IGN - pin.
These application notes are adapted to the STEPPIII-UX device.
January 2009
1.0.5
Added additional installation instructions in chapters 1.1 and 3.1.
Added Figure 1 - prior Figures 1, 2 and 3 removed.
Added chapter APPENDIX - Contains the pinout of the vehicle
installation cable for STEPPIII-UX, FOX/-LT, BOLERO-LT and
TANGO55/56/864 devices.
September 2009
1.0.6
Added additional installation instructions when using features of
the built-in 3D acceleration sensor.
December 2009
1.0.7
Made corrections and improvements throughout this document.
Added installation instructions for FOX-LT-IP - see chapter 2.1.1
September 2011
1.0.8
Added a new point (9) in chapter "1.1.1" - to filter electromagnetic
and radio-frequency interferences we recommend to use ferrite
clips at power entry point (see fig. 1).
Added the maximum and the recommended tightening torque
that can be used on the mounting nut on the FOX-LT-IP device.
Read chapter 2.1.1.
December 2011
1.0.9
Added new devices FOX-IN, FOX-EN and BOLERO-LT2.
The name FOX-LT-IP changed by DISCO-B4.
Added a new point in to the chapter 1.1.2 - Metal plates near the
antenna may disturb and attenuate the GSM signal.
Added Figure 4 - Axes of Acceleration Sensitivity for FOX-IN/EN
and BOLERO-LT2.
