In-Vehicle Installation Guidelines for FOX3-2G/3G/4G and BOLERO40 Series
12
✓
Make sure the top surface of the device is pointing upwards when tightening the mounting nut (see
example in diagram below).
✓
Finally, connect the vehicle installation cable to the 8pin connector on the external cable of the DISCO-
B4.
✓
Another mount option is to use 6 x hex cap screws M4x30 or longer (not included) - as shown on the
right side of the figure below (second mounting option). For this mount option, refer to the DISCO-B4
Hardware Manual and find out the dimensions of housing.
Figure 5
: Mounting the DISCO-B4 on the vehicle's roof
The pin out of the 8pin connector at the end of the cable is given in chapter
4.1
.
