Lightwave Communications
DVI Fiberlynx
www.lightwavecom.com
November
2001
11
DVI Fiberlynx Receiver, Audio, Serial and PS/2 Connections
5.
Connect the Receiver to AC power and turn on the switch. The status
LEDs found on the front of the unit should light. The Monitor and the CPU
may be powered up at this time.
2.5 Power Up the Equipment
The video signal from your DVI video source requires that the DVI monitor is
connected and turned on before the signal will start. If the signal is lost (cable is
unplugged, etc.) the signal will be discontinued and will not recover; the video
source must be restarted. This often means that your CPU must be restarted.
Power Up your equipment in this order (after all wiring connections are done):
1. Power Up your Monitor
2. Power Up the DVI Fiberlynx Receiver and Transmitter units
3. Power Up your CPU.
During power-up of your CPU, the video card generates a video record
depending on the DVI monitor that it senses is connected to its output. See
section 3.1 for more information relating to the video record.
