Shanghai Lansing Electronics Co., Ltd
Tel : +86 021 39921107
Fax：+86 021 39921107
Web：www.lansinglight.com E-mail：[email protected]
Add: No 609, Tahui Rd, Shihudang Town, Songjiang Dist Shanghai, China, 201612
All rights reserved by Lansing,without the written authorization of the Lansing, any part thereof shall not be reproduced or transmitted in any form.
JCL50F LED Portable Radio Controlled
Solar Helipad and Taxiway Light
7 / 8
4.Locate the light head onto the solar unit in the correct orientation to the runway. The light head is fitted with reflective
tape indicators to show light output. This colour indication should be aligned with the colour indication on the solar unit
to ensure correct alignment.
5.Fit the 4 x M6 x 20 SHCS
6.Tighten the SHCS evenly and firmly.
• It is recommended that the bolts for holding the light heads to the Solar Base units have a torque setting applied of 3Nm
for a satisfactory seal. Applying a higher Torque setting is not recommended and may void warranty. If in doubt, please
contact LANSING.
7. Remove all tools, nuts and bolts from the runway.
Replacing the Battery
The JCL50F has an internal battery compartment, which provides the user with the ability to change the battery after
years of operation.
1. Turn the unit on its side
2. Remove the four M6 x 25mm screws from the body/base section.
3. Place the unit back upright while still holding onto the base
4.Slide the chassis upwards just enough to expose the battery wiring loom terminals
5. Disconnect the battery wiring loom terminals
6. Slide the chassis further upwards until it has been removed completely
7. Remove the old battery and discard in a safe manner.
8. Place new battery onto base
9. Slide the chassis back over the new battery just enough so that the wiring loom terminals can be reached.
10. Connect the battery wiring loom terminals, ensuring that the polarity of each wire is correct beforehand.
11. Slide the chassis completely onto the base, ensuring that the chassis sits on the rubber gasket of the base properly and
that it is not contaminated.
12. Hold the chassis and base together and place the unit onto its side.
13. Replace and fasten the four M6x25mm screws to a torque setting of 1.8 - 2 Nm. Applying a higher torque setting is not
recommended and may void warranty. If in doubt, please contact LANSING.
14. Place the unit back upright.
15. To test place dark cover (towel or jacket) on top of light to activate sensor, light will come on.