6
Introduction
Chapter 2
Network Application Platforms
Press the load lever and release it from the retention
2.
tab.
Lift the load lever and then the plate.
3.
Align the cut-out of the CPU and the the notch on
4.
the socket. The CPU should fit perfectly into the
socket. Note that the CPU fits in the socket in only one
direction.
Close the plate and push the load lever to lock it back
5.
to the retention tab.
Peel off the sticker on the CPU to expose the thermal
6.
compound.
Put the heatsink on the installed CPU, match the
7.
screws with the screw holes on the board. Fasten two
screws which are opposite to each other at a time and
then the other two. It is easier this way because of the
springiness of the bracket.
Place the heatsink cover on top of the installed heatsink
8.
and screw the three screws to fasten it on the case.
Note:
The CPU heat sink could only be installed in only
1.
one direction as shown in the picture.
To protect the CPU socket pins, retain the CPU
2.
cap when the CPU is not installed.
Installing a CompactFlash Card
FW-7581 provides one CompactFlash slot. Follow the
procedures bellow for installing a CompactFlash card.
Align CompactFlash card and the card slot with the
1.
arrow pointing toward the connector.
Push the card to insert into the connector.
2.
.
CPU and the Heat Sink Installation
The FW-7581 sever system is powered by the MB-7581
sever board, which comes with one ZIF type LGA775 CPU
socket.
Follow the procedures bellow for installing a CPU
Remove the CPU socket cap.
1.
1
2
2
3
5
7
4
2
3
4
5
7
8
