Lanner electronics IAC-F847 Series, Руководство пользователя

Страница: 34 / 48

Chapter 3. Bios Setup
30
User’s Manual
Init Display First: This item allows you to decide to active whether PCI Slot of VGA card or AGP first. The
settings are Add-on Card and Onboard.
OnBoard LAN1 control: This field allows you to enable or disable the onboard LAN1 controller.
Configuration options: Disabled, Enabled
OnBoard LAN2 control: This field allows you to enable or disable the onboard LAN2 controller
Configuration options: Disabled, Enabled
Onboard FDC Controller: Select Enabled if your system has a floppy disk controller (FDC) installed on the
system board and you want to use it. If you install add-in FDC or the system has no floppy drive, select
Disabled in this field. The settings are Enabled and Disabled.
Onboard Serial Port 1 / Port 2: Select an address and corresponding interrupt for the first and second
serial ports. The settings are 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART Mode Select:
This item allows you to determine which InfraRed(IR) function of the onboard I/O chip,
this functions uses.
Onboard Parallel Port: This item allows you to determine onboard parallel port controller I/O address
setting. The settings are 378H/IRQ7, 278H/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode: There are four options SPP (default), ECP, EPP and ECP+EPP. Change the mode from
SPP to the enhanced mode only if your peripheral device can support it.
ECP Mode Use DMA: Select a DMA channel for the parallel port for use during ECP mode. The settings
are 3 and 1.