Chapter 3 BIOS Setup
31
User’s Manual
IDE Primary Master / Primary Slave
Secondary Master / Secondary Slave: Press PgUp / <+> or PgDn / <-> to select Manual, None, Auto type.
Note that the specifications of your drive must match with the drive table. The hard disk will not work properly
if you enter improper information for this category. If your hard disk drive type is not matched or listed, you
can use Manual to define your own drive type manually.
If you select Manual, related information is asked to be entered to the following items. Enter the information
directly from the keyboard. This information should be provided in the documentation from your hard disk
vendor or the system manufacturer.
If the controller of HDD interface is SCSI, the selection shall be
None
If the controller of HDD interface is CD-ROM, the selection shall be
None
Here is a brief explanation of drive specifications:
z
Access Mode: The settings are Auto, Normal, Large, and LBA.
z
Cylinder: Number of cylinders
z
Head: Number of heads
z
Precomp: Write precom
z
Landing Zone: Landing Zone
z
Sector: Number of sectors
Drive A and Drive B: Select the correct specifications for the diskette drive(s) installed in the computer.
None
No diskette drive installed
360K,
5.25 in
5-1/4 inch PC-type standard drive; 360 kilobyte capacity
1.2M,
5.25 in
5-1/4 inch AT-type high-density drive; 1.2 megabyte capacity
720K,
3.5in
3 1-2 inch double-sided drive; 720 kilobyte capacity
1.44M, 3.5 in
3 1-2 inch double-sided drive; 1.44 megabyte capacity
2.88M, 3.5 in
3 1-2 inch double-sided drive; 2.88 megabyte capacity
Note: 1. Not Installed could be used as an option for diskless workstations.
2. Highlight the listing after each drive name and select the appropriate entry.
Содержание EM-568 Series
Страница 4: ......
Страница 8: ...Chapter 1 Introduction 4 User s Manual 1 5 Board Layout...
