Lanier LD225, Сетевое руководство

Страница: 105 / 150

Remote Maintenance by telnet
99
4
• The acceptable TTL value is be-
tween 1 and 255.
smb
Use the “smb” command to configure
or delete the computer or workgroup
name for SMB.
❖
Computer Name settings
msh> smb comp
• Set computer name using up to
15 characters. Names beginning
with "RNP" or "rnp" cannot be
entered.
❖
Working Group Name settings
msh> smb group
• Set workgroup name using up
to 15 characters
❖
Comment settings
msh> smb comment
• Set comment using up to 31
characters
❖
Notify print job completion
msh> smb notif {on | off}
• To notify print job completion,
specify “on”. Otherwise, specify
“off”
❖
Deleting Computer Name
msh> smb clear comp
❖
Deleting Group Name
msh> smb clear group
❖
Deleting Comment
msh> smb clear comment
❖
Protocol settings
msh> smb protocol [netbeui
{up | down} | tcpip {up |
down}]
• Only the protocol value is shown.
snmp
Use the “snmp” command to display
and edit SNMP configuration settings
such as the community name.
❖
View settings
msh> snmp
• Default access settings 1 is as
follows:
Community name:public
IP address:0.0.0.0
Access type:read-only / trap off
• Default access settings 2 is as
follows:
Community name:admin
IP address:0.0.0.0
Access type:read-write / trap off
• If "-p" is added, you can view
settings one by one.
• To display the current commu-
nity, specify its registration
number.
❖
Display
msh> snmp ?
❖
Community name configuration
msh> snmp “number” name
“community_name”
• You can configure ten SNMP
access settings numbered 1-10.
• The printer cannot be accessed
from SmartDeviceMonitor for
Admin or SmartDeviceMonitor
for Client if “public” is not regis-
tered in numbers 1-10. When
changing the community name,
use SmartDeviceMonitor for
Admin and SNMP Setup Tool to
correspond with printer settings.
• The community name can be en-
tered using up to 15 characters.