Lanier 5222, Руководство оператора

Страница: 45 / 102

Netware 4.x, 5- Advanced Settings
NetWare Configuration 4 - 11
Netware 4.x, 5- Advanced Settings
Preparation
The following procedures use the Property Sheet method in configuring the Network Interface
Card. If you configure the Network Interface Card as a NetWare print server for the first time after
physically installing it, we recommend you use the Wizard method.
This section assumes NetWare is functional and that the necessary environment for the NetWare
Print Service is available. You should install the client software released from Novell on the
Windows before running the NWAdmin.
Setting Up as Print Server
You can set up the print server using the NDS or Bindery mode in NetWare 4.x, 5. The following
procedure is for setting up the print server using the NDS mode in NetWare 4.1. When you set up
the print server using the Bindery mode, use the NIC Setup Tool Wizard.
1
Log in to the file server as an Admin or an Admin equivalent.
2
Run the NIC Setup Tool.
3
Click [Property Sheet] and click [OK].
•
The Browse dialog of the Network Interface Card appears.
4
Click [IPX protocol].
The actual procedures for configuring your printer differ depending on whether the Network
Interface Card is configured as a print server or as a remote printer. This section describes how
to configure it in the NetWare 4.x, 5 environment.
To use NetWare 5
•
Load the IPX protocol into the file server in advance.
•
You cannot use the NDPS (Novell Distributed Print Services) mode.
Basic Procedure
Installing the NIB Setup Tool
Print Server Remote Printer
Configuring the Network Interface Board
Configuring the NetWare
Turning the power
off and on
Start the Print Server