5
2.
Mount the EZ connector hardware on the
aileron servo arm.
3.
Find the small aileron pushrod wire.
Make a 90º bend (or a "z" bend, if preferred)
1/4” from the end of the wire
Insert the wire into the control horn.
Secure the wire with a nylon swivel keeper.
4.
Insert the other end of the push rod through
the EZ connector.
Mount your servo arm on top of your servo.
5.
Repeat for the other servo in the other wing
.
2.
Locate the two aileron servo spacers.
IMPORTANT!
To ensure that any connections located
inside the wing will not come loose, either when the
wires are pulled, or during flying, always tape them
securely together with electrical tape.
3.
Lay the spacer over the cutout for the aileron
servo and mark around the outside edge.
Carefully remove the covering inside your
marks and glue the spacer plate in place.
4.
Use the string to pull the aileron wires through
the wing and exit the hole in the center sec-
tion.
5.
Mount the servo using the hardware supplied
with the servo.
6.
Repeat for the other wing.
Aileron Pushrods
1.
Gather the following items:
(2)12" Extension wires
(1) Bottom Wing
(2) Servos
(1) Electrical tape
(2) Servo spacers
