Langmatz basic plus EK523, Руководство по эксплуатации

Страница: 16 / 28

16
9.3 Mounting the bottom part of the pedestrian signal requesting device
Fig. 12
Fig. 13
Note:
For ease of installation, unplug all
connectors from the PCB in the top
part of the housing
(4) , pulling them
towards the centre!
The bottom part
(1) of the device is
pre-assembled with the steel pole
adaptor (protection against vandalism)
(2) and (flexible) pole adapter (3) .
•
Remove the plastic caps (captive) (2) .
•
Fasten the bottom part (1) of the device
to the pole with 2 M6x25 fastening
screws.
•
Note:
- Torque = 5 Nm.
- Check that the pedestrian signal
requesting device is fitted correctly
on the pole.
•
Put on the plastic caps (captive) (2)
again.
Note: Check that they are fitted
correctly. (Protection class!)
•
Reconnect all connectors to the circuit
board in the top part of the housing (3) .
•
Connect the connection cable to the
cable distributor in accordance with the
block diagram (see chapter 4).
•
Unused cores must be insulated.
A function test must be carried out
when the pedestrian signal requesting
device has been installed!
1
2
2
3
1
4
3