- 57 / 79 -
LANGER
EMV-Technik
DE-01728 Bannewitz
[email protected]
www.langer-emv.de
FLS 106 IC set / FLS 106 PCB set
Information on Using the GND 25 Ground Plane
16.3.2
The GND 25 ground plane is designed to hold TEM cell prints with a length and width of 100 mm.
Furthermore, individual test circuit boards may be developed and manufactured for measurements
on ICs or other components.
Test circuit boards can either be developed by customers themselves using the
"IC test instructions"
2
from Langer EMV-Technik GmbH or by Langer EMV-Technik GmbH on the
basis of the customer's specifications.
Installing the GND 25 Holder
16.3.3
First insert and position two T-nuts into the desired T-slot (Figure 67).
Then place the GND 25 holder on the T-slot table above the T-nuts (Figure 68). Insert the
countersunk screws M6 (hexagon socket 4 mm, DIN 7991) into the openings of the GND 25 holder
one after the other and fasten them with the T-nuts.
Figure 67: Placing the T-nut in the provided T-slot
2
Available via
