Lang ECOF-C, Инструкция по установке и эксплуатации

Страница: 14 / 32

4
General Operation & Programming cont.
Status Display
The Status Display informs the operator of the oven’s condition.
Preht:
Stands for PREHEAT. The oven is on and adjusting to the preprogrammed temperature
(350°F).
Ready:
The oven has reached the preset temperature and is waiting for product to be loaded into
.
the oven.
Cool:
The oven’s internal temperature is below what is programmed.
Hot:
The oven’s internal temperature is above what is programmed.
Done:
The time has expired for that program and the product is finished.
Help:
There is a fault in the control system; the computer will not operate until service is performed.
Control Panel Buttons
Shelf Buttons:
Place the product into the oven on one of the six shelf positions.
Close the oven doors. Press the shelf position button that
corresponds to the shelf position once for “C” product, twice for
“P” product, three times for “E” product, or four times for off. A
beeper will sound once the product is done and “done” will be
displayed. Press the flashing shelf to cancel the beeper.
Minute and Pace Timers:
The “1” button is preset to one minute, the “2” button is preset
to two minutes, and the “Pace “ buttons are adjustable from one
to thirty minutes. Press the button once to start the timer. The
display will read out the programmed time and then revert to the
previous read out. The timers will countdown internally. Time
remaining can be recalled by pressing the button again.
Canceling a timer:
Any timer can be cancelled at any time. Press and hold the
timer to be cancelled until “cancl” appears in the display.
Programming
Pace Timers:
The pace timers can be set at any time. Press and hold the “PACE” button
for three seconds. The display will read out the set time then begin to
flash. Press the “1” minute button to increase the time, or the “2” minute
button to decrease the time. Once the corrected time is set, press and hold
the “PACE” button for three seconds to exit the programming mode.
Program Enable Buttons:
The control cannot be put into the programming mode if any of the
timers are running. The two blue dots above the “CINNABON” logo are
the program enable buttons. Press the left dot then the right dot within
3 seconds to put the control into a programming mode. Once the shelf
position buttons are set, press the left dot then the right dot within 3
seconds to exit the programming mode. There will be no beeper sound
when the buttons are pressed.
Shelf Position Buttons:
Put the control into the programming mode. Press the shelf button to be
adjusted once for “C” product, twice for “P” product, or three times for
“E” product. The display will read out “00:00” then begin to flash. Press
the one-minute timer button to increase the time, or the two-minute timer
button to decrease the time. Once the correct time is set move on to
another shelf position button or exit the programming mode.