
General Operation & Programming
Convection ovens constantly circulate air over and around the product. This strips away the thin layer of moisture
and cool air from around the product allowing heat to penetrate more quickly.
Cooking times can be shortened and cooking temperatures can be reduced.
To convert standard deck oven recipes, reduce the temperatrue 50° degrees and the time by 25%.
.
Make minor adjustments as necessary.
Always weigh your product. This will give you a more consistent size, color and quality.
Check the product near the end of the initial cooking.
Do not open the oven door during baking, as this will change the baking characteristics of the oven and make it
.
difficult to determine a final program.
If the product is overdone on the outside and underdone on the inside, reduce the baking temperature.
If the product is pulling away from the edge of the pan, the temperature is too high or the cooking time too long.
A convection oven is a mechanical piece of equipment. The
same control settings will always give the same results. If
the results vary, problems may be because of changes in the
product preparation.
ECOF-C Control Panel
The Control panel consists of the following items.
.
Detailed operational descriptions are given later this
.
section.
Vent Knob:
When open, allows moisture to escape the
cooking chamber, allowing a dryer bake.
.
(ex: crispy fries)
Lights:
Turns interior lights on.
Power:
Turns the oven on and off
Status Display:
Displays the oven status (preheat, ready,
done) and is the count down timer.
Shelf Timers:
1 : Top Left,
2: Top Right
.
3: Middle Left,
4: Middle Right
.
5: Bottom Left,
6: Bottom Right
Pace Timers:
Labeled C, P, and E these buttons are
.
adjutable from one to thirty minutes.
Minute Timers:
There are two “Minute” timers:
.
“1” is programmed for one minute,
.
“2” is programmed for two minutes.
Temp Button:
When pressed this button will display the
.
current temperature inside the cooking
.
chamber.
Program Enable Buttons:
..
Hidden buttons that allow the times of the
shelf position buttons to be set.
Back-Up Controls:
These controls give you the basic operation
of the unit, until the primary electonic
controls are operational.
LIGHTS
ON
OFF
ON
OFF
POWER
Vent Knob
Shelf Timers
Status Display
Temp Button
Program
Enable Buttons
Back-Up
Controls
Minute
Timers
Pace
Timers
Lights
Power
IL1530
Содержание ECOF-C
Страница 31: ......