Lang CLG36F, Инструкция по установке, эксплуатации и обслуживанию

Страница: 7 / 16

7
INSTALLATION
DANGER:
THIS APPLIANCE MUST BE GROUNDED AT THE
TERMINAL PROVIDED. FAILURE TO GROUND THE
APPLIANCE COULD RESULT IN ELECTROCUTION AND
DEATH.
WARNING:
INSTALLATION OF THE UNIT MUST BE DONE BY
PERSONNEL QUALIFIED TO WORK WITH ELECTRICITY.
IMPROPER INSTALLATION CAN CAUSE INJURY TO
PERSONNEL AND/OR DAMAGE TO EQUIPMENT. UNIT
MUST BE INSTALLED IN ACCORDANCE WITH ALL
APPLICABLE CODES.
NOTICE:
The data plate is located behind the access panel in the
back of the grill. If on a 48” or larger, the data plate is
behind the back left access panel. The griddle voltage,
wattage, serial number, wire size, and clearance
specifications are on the data plate. This information
should be carefully read and understood before
proceeding with the installation.
NOTICE:
The installation of any components such as a vent hood,
grease extractors, fire extinguisher systems, must
conform to their applicable National, State and locally
recognized installation standards.
4.1 Electrical Connection
There is one power supply connection on 2, 3 and 4 foot griddles. There are two
power supply connections on 5 and 6 foot griddles. Refer to the power supply
chart on the next page for proper power supply size.
There is (1) one 1 1/4 inch conduit knockout on 2, 3, and 4 foot griddles located at
the rear of the griddle, through the back and the bottom of the griddle body. There
are (2) two 1 1/4 inch conduit knockouts provided on the 5 and 6 foot griddles.
Use a supply wire suitable for at least 90

C.
4.2 Griddle Voltage
This griddle is shipped from the factory wired for 208/240 or 480 volts. The
208/240 griddle is a dual voltage design. Jumper wires on terminal strip next to the
main power supply connection determine the griddle voltage. For a 208 volt power
supply, leave the jumpers in place. For a 240 volt power supply disconnect the
jumpers as indicated on the tag to the terminal strip. The 480 volt griddle can be
operated on 480 volts only.
4.3 Phasing
All griddles are shipped from the factory set up for a three phase service.
Rearrange the wires in the power supply terminal block to convert the griddle to
single phase. Rephasing the griddle is not chargeable to Star Manufacturing
International as warranty. To convert to
single phase follow the chart located on
the next page.