Lang 36S-20M-U, Установка, эксплуатация, обслуживание и устранение неисправностей

Страница: 10 / 19

10
INSTALLATION
DANGER THIS APPLIANCE MUST BE GROUNDED AT THE TERMINAL PROVIDED.
FAILURE TO GROUND THE APPLIANCE COULD RESULT IN
ELECTROCUTION AND DEATH.
WARNING INSTALLATION OF THE UNIT MUST BE DONE BY PERSONNEL
QUALIFIED TO WORK WITH ELECTRICITY AND PLUMBING. IMPROPER
INSTALLATION CAN CAUSE INJURY TO PERSONNEL AND/OR DAMAGE
TO EQUIPMENT. UNIT MUST BE INSTALLED IN ACCORDANCE WITH ALL
APPLICABLE CODES.
NOTICE The Range data is located on the serial tag, which is riveted to the front of
the unit in the lower right hand corner. The range voltage, wattage, serial
number, wire size, and clearance specifications are on the data plate.
This information should be carefully read and understood before
proceeding with the installation.
NOTICE The installation of any components such as a vent hood, grease
extractors, fire extinguisher systems, must conform to their applicable
National, State and locally recognized installation standards.
ELECTRICAL CONNECTION
A 1¼” knockout is provided on the bottom left hand side of the oven below the
control panel for power connection.
The electrical connection must be made in accordance with local codes or in the
absence of local codes with
National Electrical Code
latest edition (in Canada
use : CSA STD. C22.1 ).
Place spacers, (ie. 2 x 4 wood block not supplied) at the front and rear of the oven
top.
Place the range top on the spacers that are located on top of the oven.
The six wire leads to supply electricity to the cook top are bundled under the front
bottom of the top. Route these wires through the bushing provided in the oven
top.
Align the four locating pins in the bottom corner of the top with the four holes in
each corner of the oven top.
Remove the spacers and lower the top onto the oven.
CAUTION
MAKE SURE THE SIX POWER LEADS THAT SUPPLY ELECTRICITY TO THE
COOK TOP ARE NOT CRIMPED BETWEEN THE OVEN AND RANGE TOP.
WARNING
MAKE SURE THE MAIN POWER SUPPLY TO THE RANGE IS TURNED OFF
AT THE SOURCE PRIOR TO CONNECTING POWER TO THE RANGE.
The range can now be connected to power.
CAUTION
BE SURE THE POWER SUPPLY VOLTAGE MATCHES THE VOLTAGE
SPECIFIED ON THE NAMEPLATE LOCATED ON THE FRONT OF THE
RANGE.
Use the wiring diagram provided in this manual for determining the connections of
the cook top wires to the oven terminal block.