10
Installation
WARNING
INSTALLATION OF THE UNIT MUST BE DONE BY PERSONNEL QUALIFIED
TO WORK WITH PLUMBING. IMPROPER INSTALLATION CAN CAUSE INJURY
TO PERSONNEL AND/OR DAMAGE TO EQUIPMENT. UNIT MUST BE
INSTALLED IN ACCORDANCE WITH ALL APPLICABLE CODES.
NOTICE
The data label is located behind the front panels on the inside face of each
body side. The English label is on the left; the French language label is on
right. The griddle serial number, gas specifications, and clearance
specifications are on the data plate. This information should be carefully read
and understood before proceeding with the installation.
NOTICE
The installation of any components such as a vent hood, grease extractors,
fire extinguisher systems, must conform to their applicable National, State
and locally recognized installation standards.
Leg Installation
The legs are installed by sliding the threaded ends of the legs into the leg
receiver tubes located in each corner of the griddle.
Slide the leg up until contact is made with the threaded nut at the top of the
receiver tube. Screw the leg counter-clockwise until it is hand tight.
Tighten the setscrew on the receiver tube (one per leg).
WARNING
THIS APPLIANCE IS EQUIPPED WITH A 3-PRONG (GROUNDING) PLUG FOR
YOUR PROTECTION AGAINST SHOCK HAZARD AND MUST BE PLUGGED
DIRECTLY INTO A PROPERLY GROUNDED 3-PRONG RECEPTACLE. DO
NOT CUT OR REMOVE THIS GROUNDING PRONG FROM THE PLUG.
Electrical Connection
The electrical connection must be made in accordance with local codes or in
the absence of local codes with NFPA No. 70, latest edition (in Canada use:
CAS STD. C22.1).
The electrical service is provided by a cord and plug located at the back of the
griddle slight off center and adjacent to the gas connection.
Each griddle requires a 115-volt, 2 amp grounded supply
.
NOTICE
When this appliance is installed with casters, it must be installed with the casters
supplied, a connector complying with either ANSI Z21.69
•
CSA 6.16 and a quick-
disconnect device complying with ANSI Z21.41
•
CSA 6.9. It must also be installed with
restraining means to guard against transmission of strain to the connector as specified
in the appliance manufactures instructions.
