Laney Richter Bass RB2, Инструкция по эксплуатации

Страница: 13 / 16

13
BLOCK DIAGRAMS
EQ SECTION
EQ SECTION
This loop is a series type so all
your signal will go through your
FX unit.
GAIN
GAIN
Headphones (3.5)
Headphones (3.5)
VOLUME
VOLUME
FX LOOP
SEND RETURN
D.I.
D.I.
INPUTS
INPUTS
NORMAL
NORMAL
HI
HI
PAD
PAD
LOUDSPEAKER
LOUDSPEAKER
General Notes
Amplifier connection: In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off your
equipment. With all system parts connected, turn on source equipment, tape decks, cd players, mixers, effects processors etc.
BEFORE turning on your Bass Amplifier. Many products have large transient surges at turn on and off which can cause damage to
your speakers. By turning on your Bass Amplifier LAST and making sure its Volume control is set to minimum any transients from
other equipment will not reach your loudspeakers. Wait until all system parts have stabilised; usually a couple of seconds. Similarly
when turning off your system always turn down the Volume control on your Bass Amplifier and then turn off its power before
turning off other equipment.
Cables: Never use shielded or microphone cable for any speaker connections as this will not be substantial enough to handle the
amplifier load and could cause damage to your amplifier system.
Servicing: The user should not attempt to service these products. Refer all servicing to qualified service personnel.
Aux In (3.5mm)
Aux In (3.5mm)
POWER
AMP
POWER
AMP
ACTIVE
ACTIVE
ON
ON
COMPRESSOR
SECTION
COMPRESSOR
SECTION