Laney IRT-X, Руководство пользователя

Страница: 8 / 20

TREBLE
BASS
AUX IN
LINE OUT
MONO SEND
CLIP
POWER
>10W
<10W
DI OUT
EMULATED
SOURCE
FX RAW
SPEAKER SELECT
PEAK
DI/LINE IN
VOLUME
AMPLIFIER INPUT LEVEL FX LOOP
LIFT
LIFT
GND
GND
EXTERNAL
(TIP L RING R)
(TIP L RING R)
PHASE
0
INTERNAL
180
RIGHT
(INTERNAL)
MONO
MODE
ST
4x12
1x12
NONE
EMULATION
INPUT
8 - 16 Ù
(~30V)
LOAD/
RETURN
MONO/RIGHT
RETURN/LEFT
LEVEL CONTROL
Balances the amount of signal which appears at
the FX-Loop send – makes sure that any
external FX are driven at a desirable level.
FROM FX SEND, DI OUT TO DI/LINE IN
Connecting an IRT- Studio – use the on board
balanced XLR Di out on your IRT-STUDIO to
connect to the IRT-X using the combi XLR/Jack
feature. This socket can also be used to connect
other DSP based modelling products that are
equipped with balanced XLR outs.
MP3 PLAYER
Use this socket for connecting an external sound
source – the volume of the sound source is
controlled by its on-board volume control.
ERL FEATURE
Connecting the IRT-X utilising the ERL feature.
Simply remove your amps on-board speaker jack
and connect the speaker output socket to the
input of your IRT-X. Then connect the Load
socket back to your amps internal speaker. If
your amp has 2 speaker out sockets then there is
no need to remove the on-board speaker –
simply connect the IRT-X to the second speaker
output and there is no need to adjust the amps
impedance setting.
AMPLIFIER SELECTION SWITCH
Gives you the option of connecting amplifiers with
Less than 10W RMS or greater than 10W RMS.
FX
Use this to connect to your external FX
processor. The level of signal is controlled by the
Level control. If your FX processor has stereo
outs then you can connect the left and rights
independently. You could also send one of the
returns back to your amps FX loop to run a
stereo set up. (Any FX signal on the Mono Return
is mirrored to the Line Out socket).
CABINET EMULATION FEATURE
Switch in a 1 x 12 or a 4 x 12 Cabinet emulation
feature to the DI out signal.
ADDITIONAL IRT-X FOR STEREO
OPERATION
Use this socket to connect to an additional IRT-X
and run in Stereo Mode to give you a massive
sound. (See FX).
PA
Balanced XLR-DI out for sending your IRT-X
signal direct to the PA – no need to mic your IRT-
X. This signal can be with or without FX, Dry or
with cabinet emulation.
MONOBLOC OPTION
Connect an external speaker cabinet here in
order to utilise the IRT-X’s 200 Watts RMS output
section. Makes everything gigable!
Ensure that the selection switch is correctly
set to either External or Internal to suit your
rig!
IRT-X
7