Landxcape LX791, Руководство пользователя

Страница: 20 / 200

EN 20
The mower does not charge.
There is no power.
Check the power cord is connected properly to the
charger and the charger is connected to a suitable
power supply.
Landxcape
TM
does not operate correctly while
manually charging.
Refer to manual charging in Section 8.3.
Landxcape
TM
is starting to have shorter
run-times between charges.
Something is clogging in the blade disc. Take off the blade disc and clean it.
The grass is too high and too thick.
Check the Blade Disc and blades, remove debris and
foreign objects from the blades and Blade Disc.
Landxcape
TM
is shaking heavily.
Check the blade disc and blades, remove debris and
foreign objects from the blades and blade disc.
Landxcape
TM
is not operating at the
correct time.
The clock is not set to the correct time. Set the clock to the correct time, refer to Section 5.3.
Programmed cutting times for Landxcape
TM
are not correct.
Change the time settings for the mower to start and
stop.
Landxcape
TM
is manually docked in the
charging base.
Press then .
The battery does not charge as its temperature
rises above 55
O
C in hot weather.
Wait until the battery has cooled down.
Landxcape
TM
cannot correctly dock
with the charging base.
Environmental influences. Restart Landxcape
TM
.
Poor connection caused by debris on the
charging strip. Clean the contact pins located on the charging base
and the charging strip on Landxcape
TM
using a cloth.
The green light on the charging base
turns on before charging is complete.
The charging base is overheated.
Place the charging base in a shady area or wait until
the temperature has cooled down.
Landxcape
TM
runs outside the boundary
wire. Landxcape
TM
does not mow an
area within a boundary wire zone.
Landxcape
TM
reverses or rotates
erratically near the boundary wire.
The boundary wire of another Landxcape
TM
or another robotic mower is positioned too
closely.
Ensure your Landxcape
TM
boundary wire has at least
1m of space between the neighboring boundary wire.
The boundary wire has been installed with
tight corners. Check the boundary wire to ensure the corners are
smooth.
In wet conditions, the boundary wire electric
signal may leak were wire has been joined or
repaired.
Check boundary wire joints. Insulate to provide a fully
waterproof connection.
There is boundary wire electric signal leakage
due to broken insulation. Repair damaged boundary wire insulation with
connectors.
The cutting area is larger than the allowable
cutting area for Landxcape
TM
.
Reduce the cutting area or use Landxcape
TM
with a
larger allowable cutting area.
Landxcape
TM
wheels skid or damage
lawn.
Foreign obstacles, such as twigs and branches
may be lodged under Landxcape
TM
.
Remove foreign objects from underside of
Landxcape
TM
.
The lawn is too wet. Wait until lawn has dried.
Landxcape
TM
exits the boundary wire
due to high speed when going down a
hill.
The boundary wire is placed on a slope
steeper than 17% (10°).
Reposition the boundary wire away from slopes that
are steeper than 17% (10°). Please refer Installation
Guide for details.
Software update failure occurs. Try again according to section “Software update”.
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice.