Landxcape LX790, Руководство по установке

Страница: 12 / 172

EN 12
Setting
First please set the height to a desired grass level after cut and you can
do the program setting manually.
NOTE:
When doing the program setting manually, Landxcape
TM
will
enter the standby page if it does not receive any input from the user
within 30 seconds.
1.Change PIN code
To change the PIN code, keep pressing both and buttons at the
same time for 5 seconds. The icon will be blinking, and “
” will be rolling flashing. After that, the first number will be blinking, use
or to select the number you want and press to confirm. The
next number will be blinking. Use the same method to complete other
numbers. For example, the new PIN code is set to be 0326. After that, “
” will be rolling flashing and the first number will be blinking
again. Use the same method to input the new PIN code you set just
now (in this example,
). Then “ ” will be rolling
flashing on the display. Your PIN code has been changed successfully.
WARNING
• If your Landxcape TM is outside its territory, it will not move and “ “ will be displayed.
Move it inside its territory and repeat Verification.
• If your Landxcape
TM
is inside its territory but “ “ is displayed, please refer to “
Error Messages
” in Owner’s Manual for solutions.
• Your Landxcape
TM
should always remain switched on. If you ever need to turn it off, then make sure you place it within its boundary area before you
switching it back on again.
• Should your Landxcape
TM
stop operating, simply restart it and operate it as you normally would.
NOTE: Please refer to the Owner’s Manual for more information.
LED light indicator on
the charging base
Status Action
Light does not turn on There is no power.
Confirm that the power cord is connected properly to the charger and that
the charger is connected to a suitable power supply.
Green light on
Boundary wire is connected successfully;
Landxcape
TM
is fully charged.
/
Red light on
The boundary wire isn’t connected. Confirm that there are no breaks in the boundary wire.
Power supply is connected successfully, while
the wire is connected unsuccessfully.
Check that the boundary wire has been connected correctly to the
charging base.
Confirm that there are no breaks in the boundary wire.
Green light flashing Landxcape
TM
is auto charging. /
Only for reference
Only for reference
4. Press then to send Landxcape TM back to the charging base.
Landxcape TM will follow the boundary wire to the charging base.
5. Fine tune the outline shape of the boundary wire if necessary.
NOTE:
If the boundary wire is broken during the testing or you need to
extend the boundary wire, please refer to “
Joining the Boundary Wire”
in Owner’s Manual for instructions.
Check the status of the LED light indicator on the charging base to make
sure the connection is OK.
If the verification test is completed smoothly, you can start mowing by
pressing
then .
If there is any problem during verification test, please refer to “
Owner’s
manual-Troubleshooting
”.