L&R Quantrex Q90, Руководство владельца/оператора

Страница: 9 / 28

9
Unpack, Set-Up and Start-Up
Unpack

Remove your ultrasonic cleaner from its shipping container and
inspect it for any possible damage which may have occurred during
shipping. (Claims for shipping damage should be made immediately
against the carrier.)

Check the serial number of your machine with the serial number on
the shipping carton. If they are not the same, contact your dealer or
the factory.

Complete the warranty card and mail it to L&R Mfg. Co.
or visit www.LRultrasonics.com to register.
Set-Up
Table Top Machines

Select your desired location for the cleaner. It should be in close
proximity to a sink or waste lines to facilitate ease of draining. A drain
assembly, supplied with the cleaners having drains, will allow you to
place the unit on either side of the sink or to connect it directly into a
waste line. Provide at least two inches all around the machine to
allow for adequate cooling.
Directions for Attaching Pre-Assembled Drain Hose
for 140, 200 and 210 models
1. Open bag and remove pre-assembled drain hose.
2. Loosen large black nut on the elbow (drain fitting) at end of the
drain hose by turning 2 – 3 complete revolutions. (Be Careful:
Excessive turns will result in the black nut falling off and the elbow
coming apart.)
3. Turn the ultrasonic
machine so the back of
the unit is facing you.
Locate the metal drain
tube coming out of the
machine. Slide the elbow
(drain fitting) over the
metal drain tube until
elbow is almost flush with
back of machine. (Note:
Sliding the elbow will
require some force and it
is recommended to place
one hand on the front of
the machine for stability.)
4. To tighten elbow (drain fitting), turn the black nut counter-clockwise
while holding the elbow in place. (Be careful not to over-tighten the
black nut.)
5. Close drain hose by pressing down on pinch clamp until secure
(approximately 4 “clicks”).
6. Secure end of plastic tubing into clip at top of machine.