Landoll Weatherproofer III 2310 Series, Руководство оператора

Страница: 29 / 80

ASSEMBLY INSTRUCTIONS
3-7
Wheel Lift Installation
1. Attach base end of the 3-1/2 x 16 hydraulic cylinder
to the cylinder anchor plates of the frame assembly
using roll pin and clevis pin supplied with the cylinder
(See Figure 3-3.)
2. Attach rod end of each 3-1/2 x 16 hydraulic cylinder
to the lift using roll pin and clevis pin supplied with the
cylinder.
3. Install 90
o
adapters in each port of both 3-1/2 x 16
cylinders.
IMPORTANT
Do not use 90
o
adapters with restrictors in ports of
3-1/2 x 16 lift hydraulic cylinders.
4. At this point, the 3-1/2 x 16 lift cylinders need to be
fully retracted on both sides before the radius rod is
installed.
5. Install radius rod assembly to the frame assembly
using 1-8 x 4 hex head cap screws and hex lock nuts.
Be sure to adjust the radius rod to fit with the
cylinders fully retracted.
NOTE
Once radius rod is installed, be sure to tighten jam nuts.
6. No further adjustment should be required any other
adjustment other than this can severely damage
frame and lift components.
7. Assemble the wheels and tires to the hubs. Tighten
wheel bolts evenly to assure proper wheel alignment.
Wheel bolts should be tightened to 90 ft-lbs of
torque. The hoist can then be removed.
8. Inflate the tire as recommended by the manufacturer.