Landoll Weatherproofer III 2310 Series, Руководство оператора

Страница: 23 / 80

3-1
Chapter 3
Assembly Instructions
It is very important that your new 2310 Weatherproofer III
be properly assembled, adjusted and lubricated before
use. Illustrations to assist with the assembly process are
provided in
“Standard Specifications” on page 2-1.
They show proper shank and light mounting bracket
spacing. Illustrations in this section show proper
assembly procedures. Remove paint from grease fittings.
Replace any grease fittings that are damaged or missing.
Be sure to return screws, clips, etc., to their original
locations.
To insure alignment of assemblies, leave the nuts loose
until completion of final assembly. Use lock washers or
flat washers as specified. Spread all cotter pins.
After completion of final assembly, tighten all nuts
evenly
to prevent misalignment, distortion or binding.
Tighten all screws and nuts to the recommended torques
shown in
Table 2-1.

DANGER

WARNING

DANGER

CAUTION

CAUTION
Disc blades are extremely sharp. Exercise
extreme care when working on or near disc
blades. Do not allow disc to roll over or fall onto
any body part. Do not allow wrenches to slip
when working near disc blades. Never push
wrenches toward disc blades. Do not climb over
machine above disc blades. Failure to stay clear
of disc blade edges can cause serious personal
injury or death.
Do not attempt to lift heavy parts (such as the
frame, disc gangs, wheel lift, and pull hitch)
manually. Use a hoist or a forklift to move these
parts into position.
To prevent accidental lowering:
1. All hydraulically elevated equipment must be
locked out using the cylinder lockouts.
2. Lower equipment to the ground while
servicing or when it is idle.
Failure to take measures to prevent accidental
lowering may result in serious personal injury or
death.
Be sure to bleed the hydraulic system of all air in
lines after installation. Failure to bleed the system
of all air can result in improper machine
operation.
Incorrect adjustment of disc adjust rods will
cause permanent equipment damage.