Landoll LT10A Series, Руководство оператора

Страница: 21 / 36

MAINTENANCE AND LUBRICATION
4-5
Frame and Decks
The trailer should be thoroughly checked daily for cracks
or material fatigue. Cracks will normally show best under
loaded conditions. If any cracks or breaks are found,
immediately contact Landoll Corporation for
recommended repair. Any defective parts must be
replaced immediately.
Electrical System
1. Maintenance of the electrical system consists of
inspection and minor servicing. Any wire, connection
or electrical component showing signs of corrosion,
wear, breakage or unraveling must be repaired or
replaced.
2. Frayed or unraveling wire must have the defective
section removed and replaced with wire of the same
color and gauge. Seal all connections and insulate.
3. Corroded terminals must have the corrosion
removed, source of corrosion neutralized and the
terminals resealed, protected and insulated.
4. Fuse or circuit breaker burn-out or “blow-out” usually
indicates an electrical short-circuit, although a fuse
can occasionally fail from vibration. Insert a second
fuse or reset the breaker. If this fuse immediately
burns out or the breaker trips, locate the cause of the
electrical short and repair.
5. Lights with a repeated lamp burn-out usually
indicates a loose connection, poor system ground, or
a malfunctioning voltage regulator. Locate the source
of the problem and repair. System grounds must be
grounded to bare metal surfaces. Paint, grease, wax,
and other coatings act as insulators. Replacement
lamps must be equivalent to the factory installed
lamp.
Brake System Maintenance
Follow operation maintenance service manual from brake
and axle manufacturer. If another manual is required, it
may be obtained by requesting Landoll p/n 107482.
Hub and Drum Maintenance
Follow operation, maintenance, service manual from hub
and drum vendor that comes with each trailer. If another
manual is required, it can be obtained by requesting
Landoll p/n 107482.
Wheel Bearing
Use vendor manual for electric or hydraulic brake parts
and recommendations. If another manual is required, it
can be obtained by requesting Landoll p/n 107482.
Suspension Maintenance
Use vendor manual for suspension parts and
recommendations. If another manual is required, it can
be obtained by requesting Landoll p/n 107482.