Landoll Brillion SS4, Руководство оператора

Страница: 47 / 56

MAINTENANCE
4-3
TABLE OF CONTENTS
Front and Rear Roller
Adjustment
NOTE
Failure to position the Front Roller Clamp Band Socket
Head Bolt (Clamp Band open section) over the Roller
Drum weld seam will cause Clamp Band to loosen and
slide.
After an initial run of 5-10 hours, check the Front and Rear
Roller Assemblies to ensure that the Wheels are tight to
one another and that the Front Roller Clamp Bands and
Rear Roller Axle Clamps are tight. If not, slide the Roller
Wheels tight together and adjust the Front Roller Clamp
Bands and Rear Roller Axle Clamps per
Roller
Adjustment Procedure . Front Roller, tighten the Clamp
Band Socket Head Bolt (Clamp Band open section) over
Roller Drum weld seam to 75 Ft-Lbs. Thereafter check
Front and Rear Roller Assemblies every 50-100 hours.
Roller Adjustment Procedure
1. Adjust the Front Roller Wheels first. Loosen Clamp
Bands and slide the Roller Wheels snug against each
other, centering the entire assembly with the
Deflector.
2. Position the Clamp Band Socket Head Bolt (Clamp
Band open section) over the weld seam on the Roller
Drum.
See Figure 4-2.
3. Slide the Clamp Band against the Half End Wheel on
each end of the Front Roller and tighten the Clamp
Band Socket Head Bolt to 75 Ft-Lbs.
4. Adjust the Rear Roller Wheels. Loosen the Axle
Clamps. Start at the center of the Rear Roller and
align the peaks of the Rear Roller Wheels with the
valleys of the Front Roller Wheels as best as possible.
This will provide the best alignment of worn Roller
Wheels and maximize seed germination.
5. Slide the Axle Clamp against the end Wheel Hub on
each side of the Rear Roller and tighten the 7/16-14
Hardware per torque chart.
See "General Torque
Specifications" on page 4-1.
Figure 4-2: Roller Wheels
Axle
Clamp
Clamp
Band
Roller Drum
Welded Seam
Rear Roller
Assembly
Front Roller
Assembly
tight against
Wheel Hub
Socket
Head Bolt
Roller Drum
tight against
Wheel Hub