Landoll Brillion PPD Series, Руководство оператора и каталог запасных частей

Страница: 29 / 42

5K804
Page 20
Male &
female
ends
must
mate
and
remain
in close contact.
The above diagram shows typical wheel gang positioning of optimizer model
pulverizers using optimizer wheels. Position of axle clamps is toward the
outside end of the machine. Also,
it is especially important that fit of
wheels on the shaft remains tight. Wear and damage can result from
wheels that do not fit tightly against one another. Make frequent checks
to insure that close fit remains intact. If wheels have jostled apart,
adjustment is made by loosening and moving the clamp until the wheels
are tightly in place. Then retighten clamp.
Optimizer
Wheel
Position Axle Clamps to outside
ends & opposite Center Bearing
SPECIAL NOTE ON OPTIMIZER MODELS
6K353
Center Bearing
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
PPO
PULVERIZERS
1098ev401