Landoll Brillion PC, Руководство оператора

Страница: 47 / 64

OPERATION
F-851R0 3-5
Hydraulic System
The Pulverizer is equipped with a hydraulic system to
raise and lower the unit
.

WARNING
Figure 3-5: Hydraulic Leak Detection
If the hydraulic system is not filled with oil it should be
purged of air before transporting and field operations.
Carefully hitch the Pulverizer to the tractor or other
implement and connect the hydraulic hoses. Check to
make sure the tractor hydraulic reservoir is full of the
manufacturer’s recommended oil.
Be sure the system is fully charged with hydraulic oil
before attempting to raise and lower the unit. The system
needs to be charged with oil initially and any time the
system has been opened for repair such as cylinder,
hose, or fitting replacement/repair
Hydraulic Lift Circuit
The Pulverizer is equipped with a hydraulic lift circuit that
raises/lowers the machine. The tractor should be stopped
and not moving on a level area.
For Transport
Raise the machine. Ensure that the lift cylinder is fully
extended. Install the Transport Lock Pin for drawbar
version.
See Figure 3-2. Install Transport Lock Channel
for Bridge Hitch. See Figure 3-3.
For Field Operation
Raise the machine slightly to loosen the Transport Lock
Pin. Remove Transport Lock Pin and place it in the
storage position for drawbar version.
See Figure 3-1.
Remove Transport Lock Channel from Bridge Hitch
Cylinder Rod and place in storage position.
See
Figure 3-3. Lower the machine until the Wheel and Tire
Assemblies are off the ground and the lift cylinder is
completely retracted.
Scraper Adjustment
To adjust scrapers; lower machine on level surface.
Adjust scrapers to obtain 1/4” gap between scraper and
wheel.
NOTE
Scrapers are optional on notched and heavy notched
rollers.
Figure 3-6: Scraper Gap
Escaping hydraulic fluid can cause serious
personnel injury. Relieve system pressure before
repairing, adjusting, or disconnecting. Wear
proper hand and eye protection when searching
for leaks. Use cardboard instead of hands (See
Figure 3-5.) Keep all components (cylinders,
hoses, fittings, etc.) in good repair.
*DS
6FUDSHU
6FUDSHU7XEH
6FUDSHU%UDFNHW
)ODQJHG
/RFNQXW
8%ROW
3XOY2S6FUDSHU*DS