Landoll Brillion PC, Руководство оператора

Страница: 48 / 64

3-6 F-851R0
OPERATION
Transport
1. Check and follow all federal, state, and local
requirements before transporting the Pulverizer.
2. The Pulverizer should be transported only by tractor
required for field operation. The implement weight
should not exceed more than 1.5 times the tractor
weight. Maximum transport speed for the Pulverizer
is 20 mph for the implement and is designated on the
speed identification symbol located on the front of the
implement.

CAUTION
3. When towing equipment in combination, the
maximum equipment ground speed shall be limited
to the lowest specified ground speed of any of the
towed implements.
4. Maximum transport speed shall be the lesser of
travel speed specified in the operator's manual,
speed identification symbol, information sign of
towed equipment, or limit of road conditions.
5. Slow down when driving on rough roads. Reduce
speed when turning, or on curves and slopes to
avoid tipping. Equipment altered other than the place
of manufacture may reduce the maximum transport
speed. Additional weight, added tanks, harrowing
attachments, etc. may reduce implement load
carrying capabilities.
6. A safety chain is provided with the implement to
insure safe transport.
• The safety chain should have a tensile strength equal
to or greater than the gross weight of the implement.
The chain is attached to the lower hitch clevis hole
with two flat washers between the clamp plates to
assure a tight connection. Always use a 1” diameter
Grade 8 bolt for this connection.
• Attach the safety chain to the tractor drawbar. See
Figure 1-2. Provide only enough slack in the chain
for turning. Do not use an intermediate chain support
as the attaching point for the chain on the tractor. Do
not pull the implement by the safety chain.
Regularly inspect the safety chain for worn, stretched, or
broken links and ends. Replace the safety chain if it is
damaged or deformed in any way.
7. Check that tires are of proper size, load rating, and
inflated to manufacture specifications before
transporting. Check wheel lug bolts to ensure
tightness.
8. Know the transport heights and widths of the unit
before transporting. Use caution when transporting
near bridges and power lines.

WARNING
9. Raise the machine to full transport height.
10. Install transport lock on lift system. Do not depend
solely on implement hydraulics for transport.

WARNING
11. Transport during daylight hours when ever possible.
Always use flashing warning lights, except where
such use is prohibited by law. Make sure lights,
reflectors and SMV emblem are clearly visible and
operating. remove any obstructions such as dirt,
mud, stalks or residue that restricts view before
transporting.
Figure 3-7: SMV Sign
Excessive speed may result in loss of control of
the tractor and implement, reduced braking
ability, or failure of the implement tire or
structure. Do not exceed the implement
maximum specified ground speed regardless of
the capability of the maximum tractor speed.
Electrocution can occur without direct contact
Failure to use transport lock pins during
transport may result in permanent equipment
damage, serious injury or death