Landoll Brillion 2512 Zone Commander, Руководство оператора

Страница: 37 / 56

ASSEMBLY INSTRUCTIONS
F-1049-0421 3-9
TABLE OF CONTENTS
Coverboard Installation
1. Insert four 1/2-13 x 2-1/2 bolts into the coverboard
bracket before attaching the coverboard furrower.
( See Figure 3-5 .) Secure with 1/2-13 locknuts and
tighten only so that locking portion of nut engages
the thread. The customer will tighten these nuts after
mounting to shank.
2. Tighten the 7/16-14 flange nut to the 7/16-14 x 1-1/4
plow bolt before tightening the 1/2-13 locknut to the
1/2-13 x 1-1/2 roundhead bolt. This is to ensure that
the point of the coverboard furrower is pulled tightly
against the bracket. Make sure that the plow bolt
head is flush with the surface of the coverboard
furrower.
( See Figure 3-7 .) This hardware should be
tightened now.
Figure 3-7: Coverboard Installation
Right Hand & Left Hand Coulter
Assemblies
1. Assemble coulter adjustment tube to coulter
assembly using roll pins 1/2 x 4 and 5/16 x 4.
Assemble the coulter stop to the coulter adjustment
tube using 1/2 x 4 screw and nut.
( See Figure 3-8 .)
2. Install the coulter adjustment tube and coulter
assembly to the frame using the coulter clamp tube,
4 u-bolts, clamp plate and 5/8-11 locknuts. Do not
tighten nuts until the depth adjustment is completed.
3. Use adjustment pin and 3/16 hairpin to set desired
depth. Tighten 5/8 locknuts on the u-bolts.
4. Attach coulter blade to coulter assembly using 1/2 x
1-1/2 screws and locknuts.
Gauge Wheel
1. The gauge wheel assembly comes fully assembled
from the factory. (Horizontal Mount and Vertical
Mount Options)
2. Attach the tire and wheel assembly to the hub and
tighten the lug nuts to the proper torque as specified
on
Page 2-3 .
COVERBOARD FURROWER
COVERBOARD BRACKET
PLOW BOLT, 7/16-14 X 1-1/4
BOLT, 1/2-13 X 1-1/2
LOCKNUT, 1/2-13
FLANGED LOCKNUT, 1/2-13
FLANGED LOCKNUT, 7/16-14
BOLT,
1/2-13 X 2-1/2