Landoll Brillion 2512 Zone Commander, Руководство оператора

Страница: 30 / 56

3-2 F-1049-0421
ASSEMBLY INSTRUCTIONS
TABLE OF CONTENTS
Assembly Preparation
1. Hook up the Zone Commander to a tractor using the
three-point hitch.
2. Raise the unit about 36" and place stands under the
main frame to prevent accidental lowering.

WARNING
Jack Stand Installation
NOTE
The implement jack stands must be stored "off the
machine" for all
folding machines during transport and
field operation. This is true for both front and rear jack
stands.
Front Jack Stands - Rigid Frames
1. With the Jack Stand Weldment Bracket positioned on
the bottom side of the front Frame, (clamp facing
out), attach the Jack Mount Bracket to the top using
3/4-10 x 2 Bolts, 3/4 Flat Washer and 3/4-10
Locknut.
2. Insert the Jack Stand Weldment through the bottom
of the Jack Stand Weldment Bracket with the handle
facing out and pin at desired level (top five holes),
with 3/4 x 4 Hitch Pin and hair pin.
( See Figure 3-1 .)
3. For transport, remove the jack stand Hitch Pin, and
raise the Jack Stand Weldment up and re-pin
through bottom hole.
Front Jack Stands - Folding Frames
4. With the Jack Stand Weldment Bracket positioned on
the bottom side of the front Frame, (clamp facing
out), attach the appropriate Rest-Wing Weldment
using 3/4-10 x 2 Bolts, 3/4 Flat Washer and 3/4-10
Locknut. (The Rest-Wing Weldments have right hand
and left hand designations. The left hand Wing Rest
Plate Stops slope down toward the left and the right
hand Wing Rest Plate Stops slope down toward the
right. See Parts Manual for Rest Wing Weldments
according to model number.)
( See Figure 3-1 .)
5. Insert the Jack Stand Weldment through the bottom
of the Jack Stand Weldment Bracket with the handle
facing out and pin at desired level (top five holes),
with 3/4 x 4 Hitch Pin and hair pin.
6. For transport, remove the jack stand Hitch Pin, and
store the Jack Stand Weldment "off the machine."
Rear Jack Stands (Rigid and Folding)
1. With the Jack Stand Mount Bracket positioned on the
bottom side of the rear Frame, attach the Jack Stand
Weldment Bracket (with the clamp facing out), using
1-8 x 3 Bolts, 1" Flat Washers and 1-8 Locknuts.
( See Figure 3-2 .)
2. Insert the Jack Stand Weldment through the bottom
of the Jack Stand Weldment Bracket and secure with
the 1 x 6 Pin and 1/4 x 1-1/4 Lynch Pin.
For transport, remove the jack stand Lynch Pin and store
the Jack Stand Weldment "off the machine."
Figure 3-1: Front Jack Stand
Figure 3-2: Rear Jack Stand
Do not attempt to lift heavy parts (such as the
frame), manually. Use a hoist or a forklift to move
these parts into position.
FRAME
JACK
STAND
WELDMENT
FRONT
JACK STAND
WELDMENT BRACKET
JACK STAND
MOUNT BRACKET
(RIGID)
HITCH PIN
REST-WING
WELDMENT
LEVEL
OPTIONS
PIN,1 X 6
BOLT,
1-8 X 3
JACK STAND
WELDMENT
JACK STAND
MOUNT
BRACKET
LYNCH PIN
JACK STAND
WELDMENT BRACKET
REAR
LOCKNUT,1-8
FLAT,WASHER,1"
FLAT,
WASHER,1"