Landoll 9630FH, Руководство оператора

Страница: 64 / 108

3-20 F-1105-1120
ASSEMBLY INSTRUCTIONS
LED Light Installation
1. Attach LH and RH amber light bracket assemblies to
center frame using 1/2 x 2-1/8 x 3-1/4 u-bolt and lock
nuts
See Figures 3-15 and See Figures 3-16 for
light bracket placement location.
2. Attach ag flasher control module to bottom of right
tail light mount with 1/4 x 1-1/2 bolts and lock nuts.
3. Route the 4 and 6 pin connectors to the front of the
light mount.
4. Install the light mount and ag flasher control module
to frame assembly with 5/8 x 3-11/16 x 6-3/8 u-bolts
and lock nuts.
5. Attach the ag red single LED lamps and reflector
assembly to tail light mounts using 1/4 x 1-1/2 bolts
and lock nuts.
6. Install the rear warning light harness to the frame.
Connect 2 pin and 3 pin ends to each of the warning
lights. Connect 6 pin to the ag flasher control module
See Figures 3-14 for harness wire designations.
7. Attach front warning harness to frame. Connect 4 pin
end to the ag flasher control module.
8. Insure that the harnesses are clear of any moving
parts and secure the harnesses with tie straps
provided.
See Figures 3-16 for light harness routing.
9. Attach the smv mounting bracket to front side of the
rear cylinder mount with 5/8 x 2-1/2 bolts and 5/8 lock
nuts
See Figures 3-15 Detail A.
10. install the Landoll decal to the rear of the cylinder
mount rear.
11. Attach the SIS decal mount, SIS 20 mph decal, smv
emblem using 1/4 x 1 bolts and lock nuts.