Landoll 9630FH, Руководство оператора

Страница: 52 / 108

3-8 F-1105-1120
ASSEMBLY INSTRUCTIONS
Hitch Assembly
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.

WARNING
1. Connect hitch assembly to the front of the center
frame using 1-7/16 x 7-1/4 hitch pin, machine
busings, and 1/2 x 2-1/2 slotted spring pin
See
Figure 3-4 .
2. Install the tongue jack in the forward mounting tube
and rotate to parking position to support the front of
the hitch.
3. Insert a 3/4-10 x 7 hex bolt into the hose holder tube
on the hitch from the bottom side so the threads point
upward. Hold in place with a 3/4-10 flange nut with
the flange pointing upward as well. Do not tighten this
cap screw, so the hose holder bracket may pivot
freely in this joint.
4. Slide the hose holder bracket over the screw and
secure with another 3/4 flange nut.
5. Install a 3/8-16 x 3-1/2 all-thread screw in the front of
the hose holder bracket and secure with a 3/8-16 hex
nut.
6. Slide the hose holder clamp over the 3/8” screw and
loosely start the wing nut on top of the clamp.
Hydraulic hoses will be routed through the clamp
after assembly.
NOTE
The clamp has two sides, so that extend hoses can be
located on one side and retract hoses can be located on
the other side for reference.
7. Attach the store-a-way harness to the bottom side of
hose holder bracket using 1/4-20 x 1 hex bolts and
1/4-20 lock nuts.
Do not attempt to lift heavy parts (such as the
pull hitch) manually. Use a hoist or a fork lift to
move these parts into position.