Landoll 600A Series, Руководство оператора

Страница: 70 / 86

4-11.3 Mounting Tire and Wheel (Hub Type)
a. Make sure that all mounting surfaces are
clean and free of rust, dirt or paint. A wire
brush may be used to clean these surfaces
(See Figure 4-20) .
b. Position the inner disc wheel over the studs,
being careful not to damage the stud threads.
Make sure that the disc wheel is flat against
the mounting surface and that there is clear-
ance between the disc wheel taper and brake
drum.
c. For ball seat mounted wheels only, install
the inner capnuts on the studs and tighten to
fifty foot-pounds using the sequence illus-
trated in Figure 4-21 . Make certain that the
left-handed threads are installed on the driver
side of the vehicle and the right-handed
threads are installed on the curbside of the
vehicle.
d. Tighten the inner capnuts to full torque of
450 to 500 foot-pounds using the sequence
shown in Figure 4-21 .
e. For pilot mounted wheels , skip steps c.
and d. .
4-30
Figure 4-20 Mounting Tires and Wheels