Landoll 600A Series, Руководство оператора

Страница: 17 / 86

3-5 TRACTOR AND SEMITRAILER CHECK-OUT
WARNING
FAILURE TO PROPERLY SET AND
CHECK PARKING BRAKE, AND
CHOCK WHEELS WHEN PARKING
AND DURING STORAGE, COULD AL-
LOW MOVEMENT OF THE
TRUCK/SEMITRAILER RIG RESULT-
ING IN SERIOUS PERSONAL INJURY,
DEATH, OR DAMAGE TO PROPERTY
IN ITS PATH.
3-5.1 With hydraulic power operating, raise
landing gear:
CAUTION
ALWAYS GRIP CRANK HANDLE SE-
CURELY WITH BOTH HANDS. NEVER
SHIFT LANDING GEAR UNDER LOAD,
LEAVE THE GEARS IN NEUTRAL OR
LEAVE THE CRANK UNSECURED.
a. For pin drop landing gear, activate the
TRAILER TILT lever “UP” (See Figure 3-4)
until weight is off the landing gear. Raise
landing gear. (See Section 3-9 for operation
of TRAILER TILT lever.) Secure each leg
with a park stand retaining pin in the full “up”
position before transporting.
b. For crank landing gear, retract landing gear
by turning hand crank on control panel coun-
terclockwise. Use low gear until the load is off
the landing gear. Then shift to high gear and
continue cranking until fully retracted. Leave
the landing gear in high gear.
c. For hydraulic landing gear, remove the pin
from each landing gear leg. Retract landing
gear using lever (See Section 3-5.2) on en-
gine control panel (See Figure 3-10) . Secure
each leg with a pin in fully retracted position.
3-5.2 The LANDING GEAR lever is located
on the left side of the Engine Control Panel.
It has three positions:
RETRACT In this position, the landing gear are
pulled up off the ground.
CENTER This is neutral position.
EXTEND In this position, the landing gear are
lowered to the ground.
CAUTION
1. LANDING GEAR LEGS MUST BE
FULLY RETRACTED AND SECURED
WITH PINS BEFORE OPERATING OR
MOVING SEMITRAILER.
2. IF SEMITRAILER IS LOADED WHEN
OPERATING LANDING GEAR, LOAD
MUST BE CENTERED ON THE
TRAILER.
3. DO NOT TILT SEMITRAILER WITH
HYDRAULIC LANDING GEAR ON
GROUND.
3-5.3 Activate the TRAILER TILT lever (See
Section 3-9) “DOWN” until the semitrailer is
fully lowered. Hold semitrailer tilt lever in the
down position until hydraulic system works
against the bottomed out Hydraulic Tilt Cylin-
ders.
3-5.4 Determine that the traveling undercar-
riage is completely slid back to transport po-
sition. Hold AXLE CONTROL lever (See
Section 3-10) in the transport position until
hydraulic system works against the fully ex-
tended hydraulic telescopic axle cylinder.
Shut off hydraulic power.
3-5.5 Check the operation of all lights and sig-
nals on the semitrailer for proper response to
switch positions (stop, right turn, left turn,
and clearance). Check operation of remote
function if present.
3-5