3-2
F-1058-0820
ASSEMBLY INSTRUCTIONS
Pull Hitch Assembly
1.
Carefully raise the pull axle hitch assembly and
install tire/wheel assemblies with lug nuts. Place
support jacks under the front of the hitch axle to hold
the axle level
model 5510-12.5’ or
for model 5510-15’.
2.
Carefully position the hitch assembly over the axle
assembly and lower to the axle. Install the 3/4-10 x
3-1/2 hex screws, 3/4 flat washes on top side, secure
with the 2-hole plates and lock nuts on bottom side.
3.
Remove jack from storage position and attach in the
parking position to support front of hitch assembly.
4.
Carefully move the fully assembled hitch assembly in
front of drill.
5.
Remove the lower and upper hitch pins, lower hitch
spacers.
6.
Align the holes in the rear of the drawbar hitch with
the holes on inside of lower 3 point plates. Align the
lower hitch spacers against inside lower plates,
secure with the lower hitch pins and lynch pins.
7.
Raise or lower jack to align hole in top link weldment
to top holes in the upper plates on front of drill frame.
Secure with upper link pin and quick hitch pins.
8.
Be sure the 396” light harness is routed through the
hitch, hose support clamps on top link and plug into
the ag flasher plug.
9.
Connect the drill pull hitch to the tractor before
attempting to lift the drill or remove the parking
stands.
