Landoll 425B Series, Руководство оператора

Страница: 23 / 88

OPERATING INSTRUCTIONS
3-9
Figure 3-5: Outrigger Platform Extension
Swingout Outrigger Platform
Extension Set-Up (Option)
1. Unlatch and fold out swing-out outriggers (See
Figure 3-5.)
2. Unlatch pull-out extension by pulling spring loaded
latch pin. Slide extension out until it latches again.
3. Place planks on outriggers and assemble end to end
using braces, 3/8”-16 x 2-1/4” bolts, washers, and
nuts.
4. Plank joints must be centered on outriggers.
5. To remove pull-out extension, reverse steps 1 thru 3.
6. Remove only two bolts for each joint (See
Figure 3-5.) Leave braces attached to boards for
storage.
2X 129-13/32”
CUT AT 30º ANGLE
ON ONE END
2X 98-1/4”
CUT AT 30º ANGLE
ON ONE END
1-3/8” X 10” PLANKS
REMOVE BOLTS
4X 113”
CUT AT 30º ANGLE
BOTH ENDS
SWINGOUT
OUTRIGGERS
PULL-OUT
EXTENSION
outrigger platform extension