Landoll 345C, Руководство оператора

Страница: 17 / 64

3-6.4 The trailer wheels track to the inside of
the towing vehicle during turns. Thus, turning
corners requires a wide swing to prevent
“curb hopping”, and to allow the trailer to
clear any obstacle on the inside of the cor-
ner.
3-6.5 To stop, use a gradual and smooth appli-
cation of brakes.
3-6.6 Backing should be done with care. Tail
overhang, trailer length, and allowable space
must be taken into consideration.
3-6.7 The load on the trailer should be posi-
tioned so a minimum of 8% of the total
weight and a maximum of 30% of the total
weight is on the hitch.
3-7 PARKING THE TRAILER
3-7.1 Position truck/trailer rig on a level, solid
surface.
3-7.2 Set the PARKING BRAKE , not the
trailer hand brake , and check for proper brake
holding.
3-7.3 Chock wheels of trailer.
3-7.4 Check for any air leaks in lines, relay
valve, brake air chamber, or any other air
system component.
3-8 UNCOUPLING TOWING VEHICLE FROM TRAILER
3-8.1 Park the trailer according to instructions
in Section 3-7.
3-8.2 Disconnect emergency and service air
lines.
3-8.3 Disconnect the electrical cable and store
so end is not on the ground.
3-8.4 Disconnect safety chains from the tow-
ing vehicle.
3-8.5 Lower the landing gear to the ground.
Tilt trailer bed up so next landing gear pin
hole is available. Install and lock landing
gear pins. Unlock pintle hitch. Tilt trailer bed
down until pintle hitch eye lifts off pintle
hook.
3-8.6 Shut off towing vehicle hydraulic supply,
disconnect hydraulic hoses.
3-8.7 Verify that all service lines and safety
chains are disconnected and trailer wheels
are chocked.
3-8.8 Pull towing vehicle away from the trailer.
3-5