Landoll 318C, Руководство оператора

Страница: 20 / 76

3-4.4
Pull out pivot tube weldment until dock
leveler cylinder clears the outside edge of
the trailer.
3-4.5
Rotate the pivot tube weldment and
dock leveler hydraulic cylinder until the hy-
draulic cylinder is in a vertical position.
(These parts are bolted together and will
move as one unit.)
3-4.6
Use the
DOCK LEG (REAR LIFT)
CONTROLS
to extend the cylinder piston to
the ground until the holes in the pivot tube
weldment line up with the dock leveler
weldment.
3-4.7
Install pivot tube pins into two holes in
dock leveler weldment through pivot tube
weldment. Use 3/16 x 2-1/4 cotter pins to
hold pivot tube pins in place.
3-4.8
Install the six 1-8 x 8 hex head cap
screws through pivot tube weldment and
dock leveler weldment. Use 1-8 hex nuts and
torque to 400 ft.-lbs.
3-4.9
Retract the dock leg cylinders. Connect
the footpad weldment to bottom of the dock
leveler and pin.
3-4.10
Return air raise switch to "OFF" position
and operate the suspension air dump switch
to "ON" position to deplete air from suspen-
sion air bags before lifting trailer off the
ground.
3-4.11
Use the
DOCK LEG CURBSIDE
and
DOCK LEG STREETSIDE LEVERS
and the
5th WHEEL TILT LEVER
to raise the trailer
up evenly front to back and side to side off
the ground.
3-4.12
Reverse
steps 3-4.3 through 3-4.11
to
move dock leveler back to the transport
position.
3-4.13
Turn "OFF" suspension air raise and
suspension air dump to allow suspension to
go to automatic ride height contro for high-
way operationl.
3-5 REMOTE CONTROL
3-5.1
The wireless radio remote has six mo-
mentary switches that operate the functions
as labeled on the hand held remote
(See
Figure 3-4)
. The remote controls the hydrau-
lic valve that operates the function labeled.
3-5.2
The remote must be turned on before
any of the functions will operate. Leave the
switch off until you are ready to operate the
trailer.
3-8
WINCH
IN OUT
FRONT LIFT
DWN
LEG
UP
DWN UP DWN UP DWN UP
LH REAR LIFT RH REAR LIFT TRAILER TILT
U/C TRAVEL
FWD REAR
LANDOLL
COMPLIES WITH (DOC) GRR 11 6.(4)
FN CONFORMITE AVEC (MDC) RCR 11 6.(4)
m118640
ON-OFF SWITCH
FIGURE 3-4 REMOTE CONTROL SWITCH PANEL