Landoll 1550 Series, Руководство оператора

Страница: 21 / 36

ASSEMBLY INSTRUCTIONS
3-9
Figure 3-5: Electrical Installation
Electrical Installation
1. Attach right and left hand warning light assemblies to
warning light brackets already attached to the frame
using 1/4-20 x 1-1/4 hex head cap screws and hex
lock nuts. Insure the wires are in the groove in the
base of the light toward the mounting surface on the
bracket. Assemble one light for left side and one for
right side. The red light should be to the rear with the
amber light being the outermost light
(See
Figure 3-5.)
IMPORTANT
Make sure lights are positioned for maximum
visibility from the rear.
2. Install the rear wiring harness between the lights
using extension harness where necessary.
3. Install the main short harness and connect to the
rear warning harness.
4. Insure that the harnesses are clear of any moving
parts and secure the harnesses with tie wraps
provided.
5. Install the stor-away holder bracket on bolt in coulter
clamp plate and assemble harness stor-away to
bracket with 1/4-20 x 3/4 hex head cap screws and
hex lock nuts.
1/4-20 X 1-1/4 HEX
HEAD CAP SCREW
RH WARNING LIGHT
1/4-20 HEX LOCK
NUT
MAIN SHORT
LIGHT
HARNESS
SELF-LOCKING
TIE
m1550-elect
HARNESS EXTENSION
REAR WIRING HARNESS
1/4-20 HEX LOCK NUT
STOR-AWAY
BRACKET
HARNESS STOR-AWAY
1/4-20 X 3/4 HEX HEAD CAP
SCREW
HOLDER
RH WARNING
LIGHT
WARNING LIGHT
BRACKET
4-PIN
CONNECTION
7-PIN
CONNECTION
C
A
B
D
BRN. 6
GRN. 5
YEL. 3
GRND. 1
WIRING CHART
#1 WHITE
#2 BLACK
#3 YELLOW
#6 BROWN
#5 GREEN
#4 RED
#7 BLUE
FACING CONNECTOR