Landmann miton 4.1, Сборка и руководство по эксплуатации

Страница: 9 / 28

9
miton 4.1
Disconnecting the gas cylinder
1. Close the cylinder valve.
2. Store the pressure regulator with the gas hose
under the barbecue. Make sure the gas hose is
not kinked or twisted in any way.
3. Store the gas cylinder correctly:
– Fit the gas cylinder valve with a cap nut and
safety cap.
Do not store the gas cylinder in rooms below
ground level, in or near stairways, hallways
or passages and thoroughfares between buil-
dings.
Always store gas cylinders upright, even if they
are empty!
Connecting the gas cylinder
1. Connect the coupling nut of the pressure regula-
tor to the cylinder valve thread and tighten the
coupling nut by turning it anti-clockwise by hand.
2. Do not use any tools for this, as the cylinder valve
seal could be damaged in the process, resulting in
leaks.
3. Make sure that the pressure regulator and the gas
hose are securely connected.
4. Check to make sure the connection between the
gas hose and adjusting element, as well as the
connections between the gas hose are secure.
Make sure that the hose is not kinked or twisted in
any way and that it is not under tension.
5. Place the chain around the neck of the gas cylinder
and close the ends with the snap hook to secure
the gas cylinder against tipping over.
If you don't secure the gas cylinder with the chain,
the cylinder might tip when you move the bar-
becue, thus causing damage to the barbecue or
uncoupling gas lines.
6. Open the cylinder valve and use a standard leak
detector to make sure that all of the connections
are tight.
– Please observe the instructions for the leak indi-
Before starting
• Select a suitable, preferably wind-sheltered area
to set up the barbecue. Make sure that ...
– there are not, and will not be, any flammable
materials or substances nearby. The minimum
distance to flammable materials or substances
must be 2 m overhead and 1 m to the side of
the barbecue; the distance to flame-resistant
materials or substances must be at least 0.25 m.
– the barbecue is positioned firmly on a suffici-
ently large area. It must not be moved during
operation.
– Position the gas cylinder on the base of the
trolley below the barbecue.
– Never lay the gas cylinder on its side.
– Do not kink the gas hose or apply a tension to it.
• Make sure that the seal in the pressure regulator
is present and intact. Do not use any additional
seals.
• When connecting the gas cylinder ensure that the-
re are no sources of ignition within a 5 m radius.
Important note: to avoid the risk of spark-over, do
not to light naked flames, do not smoke and do
not actuate the switches of electric devices (appli-
ances, lights, door bells, etc.).
cator! Never check for leaks using a naked fla-
me. Listening for leaks is not a reliable method
of detection.
– If a leak is detected, close the cylinder valve
immediately and tighten the loose connection
or replace the leaking part. Repeat the leak
test.
7. If you do not wish to barbecue immediately, close
the cylinder valve.
Battery
1. Unscrew the cover on the battery compartment
anti-clockwise.
2. Insert a new (type AA) battery, observing correct
polarity. Use only type AA batteries.
3. Screw the cover back onto the battery compart-
ment.
+