Information Functions Released
31/35
Cashpower Gemini HMI
– User Guide
© Gyr (Pty) Ltd
13.11 Low Credit Level (Register 012)
The meter displays the level at which the lower two credit wedges on the LCD come into operation.
Note that this function is handled differently when the meter is operating in Energy Management Mode
(refer to section 11)
13.12 High Credit Level (Register 013)
The meter displays the level at which the upper two credit wedges on the LCD come into operation.
Note that this function is not applicable when the meter is operating in Energy Limiting Mode (refer to
section 11).
13.13 Power Limit Level (Register 014)
The meter displays the power level (in either Amps or Watts) at which the load switch will be opened,
causing the supply to the customer to be interrupted.
13.14 Extended Meter Number (Register 024)
The „extended meter number‟ displays the „missing‟ three digits of the STS meter number in the format
„07- - - - - n‟ where:
07 is the manufacturer code (07 for S. African manufactured Gyr meters).
n represents the check digit.
13.15 Scrolling Meter Number (Register 025)
The meter displays the entire (11-digit) meter number i.e. the meter number as described in section
13.1 and the extended meter number as described in section 13.14, by scrolling it in from left to right
on the LCD.
13.16 Meter (Fixed) State Register 1 (Register 030)
The meter displays the state in which the meter currently is. Note that these values are stored in the
meter‟s EEPROM and will be maintained even if the meter is powered down:
Meter (Fixed) State Register 1
Display
Function
XXXX XXX
1
Load switch „armed‟ for manual re-closure
XXXX X
XX
X
XXXX X
XX
X
01 = Prepayment mode
Active metering mode:
10 = Credit metering mode
11 = Energy limiting mode
XXXX
1
XXX
Significant reverse energy detected
XXX
1
XXXX
Stop DAE incrementing when load switch forced open
XX
1
X XXXX
Not used
X
1
XX XXXX
Not used
1
XXX XXXX
Not used
