Repair Procedures
Elevation Assembly Wheels
92
5. Lubricate as follows with Lubriplate white lithium grease (Landice item #71061 with a small brush:
• Both ends of the impact absorbers
• The bottom of the nylon spacer
• The entire shaft of the post but not the threads
6. Do one of the following:
•
For L7 models
: Place all absorbers and load washers in position on the slats, insert the post and thread it into
the slat.
•
For L8 and L9 models:
Install the post and nylon spacer. Install the greased impact absorber and load washer
on all posts.
7. Use the locking pliers to tighten the posts into the slats securely, 1/4 turn past snug.
8. Install the deck, see “Deck and Treadbelt” on page
7.22. Elevation Assembly Wheels
1. Block the treadmill up on a stable platform such as a 4” x 4” x 36” piece of wood as shown in the following figure.
Figure 7-28.
Elevation Assembly Wheel
2. Remove the hitch pin and then slide out the axle, the wheel will drop out.
3. Installation is the reverse of removal.
Wooden
support
Hitch pin
Wheel
Axle
Содержание L7 Club
