1 800 - LANDICE | [email protected] | WWW.LANDICE.COM
LANDICE, INC.
111 CANFIELD AVE., SUITE A-1
RANDOLPH, NJ 07869
PHONE: (973) 927-9010
FAX: (973) 927-0630
[email protected]
Proper lubrication is required to prevent unwanted noise/squeaks from the suspension
components. Only use Lubriplate when replacing or servicing suspension components.
1.
Use Lubriplate (white lithium) grease (
Landice item #71061
) and a small brush to apply the grease on
the deck post. Make sure the grease is applied to the entire deck post. (
Figure A
)
2.
Apply the Lubriplate grease on the top of each absorber. (
Figure B
)
3.
Place the end of the absorber
without
the grease to meet the other absorber
with
grease. Rub them
together. Repeat this step for the other side. (
Figure C
)
4. For L8/L9 Machines:
place some Lubriplate grease on the bottom of each nylon spacer. (
Figure D
)
1.
Place all absorbers and load washers at both ends of each deck slat. (
Figure A
)
2.
Slide the deck post through the load washer and impact absorber. (
Figure B
)
3.
Tilt the deck post, load washer and impact absorber to align the deck post to the threads in the deck slat.
Thread the deck post by hand at first. (
Figure C
)
4.
Use a pair of locking pliers, grip the tip of the deck post, angling the handle of the pliers upwards (
Fig. D
)
5.
Turn the vice grips
clockwise
to secure the deck post down. Once the deck post is snug, give an
additional 1/4 turn to fully tighten.
6.
For L8/L9 Machines
: Thread the deck post by hand to get it started. Do not tighten to the point that the
post meets the slat. (
Figure E
)
7.
Slide a nylon spacer on the post. Using a rubber mallet, tap it all the way down the post. (
Figure F
)
Using the locking pliers, tighten the deck post down completely.
8.
Install full set of absorbers. Reverse the steps show to re-install treadmill components.
Please Note: Absorbers must be
installed with the cupped side
facing up. If installed incorrectly,
the absorber may stick to the
deck slat and cause noise issues!
Lubricating VFX Components
Reinstalling VFX Components