Landa SLT6-32624E Скачать руководство пользователя страница 11

Страница: 11 / 24

Landa SLT/SL

X Kubota Diesel Operator Manual • 9.807-540.0 • Rev. 6/13

PRESSURE W

ASHER

OPERA

TOR’S MANU

SHUT DOWN AND CLEAN-UP

CAUTION: Always store your pressure washer in a
location where the temperature will not fall below
32°F (0°C). The pump in this machine is susceptible
to permanent damage if frozen. FREEZE DAMAGE
IS NOT COVERED BY WARRANTY.

1. Stop the pressure washer, squeeze spray gun

trigger to release pressure.

2. Detach water supply hose and high pressure

hose.

3. Turn on the machine for a few seconds, until re-

maining water exits. Turn engine off immediately.

4. Drain the fuel and oil from the engine.
5. Do not allow high pressure hose to become

kinked.

6. Store the machine and accessories in a room which

does not reach freezing temperatures.

CAUTION: Failure to follow the above directions will
result in damage to your pressure washer.

When the pressure washer is not being operated or is
being stored for more than one month, follow these
instructions:
1. Replenish engine oil to upper level.
2. Drain diesel from fuel tank, fuel line, fuel valve and

carburetor.

3. Pour about one teaspoon of engine oil through the

spark plug hole, pull the starter grip several times

and replace the plug. Then pull the starter grip slow-
lyuntil you feel increased pressure which indicates
the piston is on its compression stroke and leave
it in that position. This closes both the intake and
exhaust valves to prevent rusting of cylinder.

4. Cover the pressure washer and store in a clean, dry

place that is well ventilated away from open flame
or sparks.

NOTE: The use of a fuel additive, such

as STA-BIL

, or an equivalent, will minimize the

formulation of fuel deposits during shortage. Such
additives may be added to the gasoline in the fuel
tank of the engine, or to the gasoline in a storage
container.

After Extended Storage

CAUTION: Prior to restarting, thaw out any
possible ice from pressure washer hoses,
spray gun or wand.

Engine Maintenance

During the winter months, rare atmospheric conditions
may develop which will cause an icing condition in the
carburetor. If this develops, the engine may run rough,
lose power and may stall. This temporary condition can
be overcome by deflecting some of the hot air from the
engine over the carburetor area.

NOTE: Refer to the

engine manufacturer's manual for service and mainte-
nance of the engine.

STORAGE

STEP 2: Turn burner switch off and
continue spraying, allowing the wa-
ter to cool to below 100°.

STEP 3: Turn engine key switch
off.

STEP 1: Remove detergent suction
tube from container and insert into
one gallon of fresh water. Open
detergent valve, pull trigger on
spray gun and siphon water for one
minute.

98075400-21

Burner
Switch

STEP 5: Squeeze trigger on spray
gun to relieve remaining pressure.

STEP 4: Turn off water supply.

Engine

Key

Switch

9.8

01-

427

GLST

DO NOT OVE