Landa PG Series, Руководство оператора

Страница: 8 / 32

LANDA PG 8.913-910.0
OPERA
TOR’S MANU
AL
PRESSURE
W
ASHER
8
CA
UTION
Nev er U
se:
• Bleach
, chlor
ine
produ
cts
and othe
r corrosi
ve ch
emicals
• Li qui
ds
conta
ini ng solv
ents (i
.e. p
aint th
inner
,ga soline
,oil)
• Tr
i-so
dium ph
osphate
prod
uct
s
• Ammo
nia pro
ducts
• Acid
-based p
rod uct
s
The
se ch
emicals
wil l ha
rm
the uni
t and will
damage
the
surf
ace being
clean
ed.
Use manuf
actu
rer's det
ergents a
s recommend
ed in
manual
CA
UTION
Nev
er Us
e:
• Bleach,
chlo rine produ
cts
and
othe
r co rrosi
ve c
hemical
s
• Liqui
ds co
nta ining
so
lvent
s (i.e
. pain
t th inner
,gas
oline
,oil)
• Tr
i-so diu
m phospha
te prod
uct
s
• Ammonia p
rodu
cts
• Acid-based
products
Thes
e c hemica
ls will ha
rm t
he un
it an
d w
ill damag
e the
surf
ace be
ing clean
ed.
Use man
ufa ctur
er's
dete
rgen
ts as rec
ommen
ded in manu
al
ASSEMBLY INSTRUCTIONS
STEP 1: Attach a 5/8" garden hose
to inlet connector. Minimum flow
should be 6 gpm.
STEP 2: Attach high pressure hose
to discharge nipple using quick
coupler. Lock coupler securely into
place by pulling back coupler col-
lar and inserting it onto discharge
nipple, then pushing collar forward
to lock in place.
STEP 3: Attach wand to spray
gun. Attach swivel connector on
discharge hose to spray gun us-
ing teflon tape on threads. Attach
swivel connector on high pressure
hose to spray gun using teflon tape
on threads. Engage safety latch to
prevent from triggering gun.
STEP 4: Remove oil plug on top of
pressure washer pump and replace
with dipstick supplied. (This may be
installed from the factory.)
Check oil level on sight glass on
back of pump. Oil should be visible
one half way up sight glass (30W
non-detergent).
STEP 6:
Fill gasoline tank and
check engine oil.
Notice: Running the engine with
a low oil level can cause engine
damage.
STEP 5: Use a group U1, 12 volt, 30 amp hour battery (garden tractor
battery). Secure U1 battery to the battery holder using the battery clamp
provided.
To reduce the possibility of sparking attach the battery cables in the fol-
lowing order. First attach the positive battery cable (red) to the positive “+”
terminal of battery. Next, attach the negative battery cable (black) to the
negative “-” terminal of the battery. To disconnect the battery remove the
cables in the opposite order as installed.
WARNING: Wear eye, hand and skin protection when handling or
connecting battery.
WARNING: Batteries generate explosive gases during normal battery
operation. DO NOT expose the battery to flame or sparks as these
gases may ignite.
WARNING: Battery fluid is highly acidic. If battery fluid contacts skin
or clothing, wash immediately with soap and water. If battery fluid
enters eye, immediately flood eye with running cold water for at least
15 minutes and get immediate medical attention.
NOTE: The battery must be capable of accepting ring terminals.
NOTE: Battery and battery cable mounting bolts and nuts are not
provided.
High
Pressure
Hose
Wand
High
Pressure
Hose
Spray
Gun
Fuel
Cap
Electric Start
Models Only
Garden
Hose