14
Operations
Shutting Down &
Clean-up
STEP 1:
Remove
detergent suction tube
from container and insert
into one (1) gallon of
fresh water. Pull trigger
on spray gun and siphon
water for one minute.
STEP 2:
Turn pump
switch ON or turn knob to
pump position then open
spray gun to allow water
to cool.
STEP 3:
After water has
cooled to less than 100°,
turn switch or knob to
OFF and turn off water.
STEP 4:
Squeeze trigger
on spray gun to relieve
remaining pressure.
Move shut-off gun safety
latch into its locked
position.
Landa HOT Series Operator’s Manual 8.917-208.0 - B
Storage
CAUTION: Always store your pressure washer in a
location where the temperature will not fall below 32°F
(0°C). The pump in this machine is susceptible to per-
manent damage if frozen. FREEZE DAMAGE IS NOT
COVERED BY WARRANTY.
ATTENTION: Toujours entreposer la laveuse à
pression dans un endroit où la température ne sera
pas inférieure à 32°C (0 °F). La pompe sur cette
machine est susceptible de subir des dommages si
elle est exposée au gel. LES DOMMAGES DUS AU GEL
NE SONT PAS COUVERTS PAR LA GARANTIE.
1. Stop the pressure washer, squeeze spray gun
trigger to release pressure.
2. Detach water supply hose and high pressure hose.
3. Turn on the machine for a few seconds, until
remaining water exits. Turn engine off immediately.
4. Drain the gas and oil from the engine.
5. Do not allow high pressure hose to become kinked.
6. Store the machine and accessories in a room which
does not reach freezing temperatures.
CAUTION: Failure to follow the above directions will
result in damage to your pressure washer.
ATTENTION: Le non-respect des directives ci-dessus
entraînera des dommages à la laveuse à pression
When the pressure washer is not being operated or is
being stored for more than one month, follow these instruc-
tions:
1. Replenish engine oil to upper level.
2. Drain gasoline from fuel tank, fuel line, fuel valve and
carburetor.
3. Pour about one teaspoon of engine oil through the
spark plug hole, pull the starter grip several times and
replace the plug. Then pull the starter grip slowly until
you feel increased pressure which indicates the piston
is on its compression stroke and leave it in that
position. This closes both the intake and exhaust
valves to prevent rusting of cylinder.
4. Cover the pressure washer and store in a clean, dry
place that is well ventilated away from open flame or
sparks.
NOTE: The use of a fuel additive, such as STABIL
®
, or
an equivalent, will minimize the formulation of fuel
deposits during shortage. Such additives may be added
to the gasoline in the fuel tank of the engine, or to the
gasoline in a storage container.
A
fter Extended Storage
CAUTION: Prior to restarting, thaw out any
possible ice from pressure washer hoses,
spray gun or wand.
ATTENTION: Avant de redémarrer, faire fondre la glace
se trouvant sur les boyaux, le pistolet pulvérisateur ou
la lance de la laveuse à pression
Engine Maintenance
During the winter months, rare atmospheric conditions
may develop which will cause an icing condition in the
carburetor. If this develops, the engine may run rough, lose
power and may stall. This temporary condition can be
Pump
Switch
Pump
Knob
