Land Pride STB1560, Руководство оператора

Страница: 19 / 36

Section 2: Adjustments
Table of Contents
11/27/18 STB1560, STB1572, STB1584 & STB1596 Snow Trip Blade 301-493M
15
Manual Angle Adjustment
Refer to Figure 2-3:
Holes are provided for angling the blade on each side of
center in 15
o
increments up to 30
o
for the Snow Trip
Blade.
DANGER
!
To prevent serious injury or death:
Always check all blade hardware for tightness before moving
or working around the unit. Make sure moldboard is secured
with hex slotted nut and cotter pin. If cotter pin is missing, the
slotted nut can unscrew allowing the moldboard to fall from its
pivot mount.
WARNING
!
To prevent serious injury or death:
Do not come in contact with turntables or stick objects into the
turntable holes while adjusting the unit’s angle. Doing so can
pinch or shear body extremities and objects.
1. Operate your loader lift lever to raise the Snow Trip
Blade off the ground high enough to pivot the blade.
2. Set blocks under the hitch plate assembly (A) and
lower the Snow Trip Blade on to the blocks.
3. Shut tractor engine off and remove switch key.
4. Pull bent pin (#1) and rotate blade (#3) to the left or
right.
5. When blade is at desired angle, reinsert bent pin in
center hole location (#2) as shown.
Spring Adjustment
Refer to Figure 2-4:
Over time and use, the springs on the Snow Trip Blade
can become stretched and/or loosened. Periodically
check to see if the springs (#5) on the Snow Trip Blade
are loose. Tighten the 2 nuts (#1) on eye bolt (#4) so
that the spring is tight and not loose. Adding extra flat
washers (#2) to the existing flat washer (#3) may be
necessary to stretch the springs tight.
NOTE: The STB1596 is not offered with a bent pin.
Therefore, the blade angle can not be adjusted
manually on the STB1596.
IMPORTANT: The Snow Trip Blade must be hitched
to a tractor and raised a few inches off the ground to
make the following adjustment.
Manual Angle Adjustment
Figure 2-3
Spring Adjustment
Figure 2-4
39702
39674