Land Pride SSP2510, Руководство оператора

Страница: 22 / 30

Section 3: Adjustments
Table of Contents
3/28/14 SSP2510, & SSP2512 Snow Pusher 303-348M
18
Blade Adjustments
Preparation
DANGER
!
To avoid serious injury or death:
•
Always secure equipment with solid, non-concrete supports
before working under it. Never go under equipment
supported by concrete blocks or hydraulics. Concrete can
break, hydraulic lines can burst, and/or hydraulic controls
can be actuated even when power to hydraulics is off.
•
Make adjustments to the Snow Pusher with unit attached to
the loader arms and properly blocked. The Snow Pusher is
back heavy and can tip over backward if unhooked from the
loader arms.
1. Park tractor/skid steer and Snow Pusher on level
ground. Lower Snow Pusher until skid shoes are
resting on 4" to 6" high support blocks to hold the
snow blade off the ground.
2. Shut down tractor/skid steer properly before
dismounting to adjust blade(s). Refer to
“Power
Machine Shutdown Procedure” on page 15.
3. Verify skid shoes are mounted in the 3rd hole down.
If not, readjust skid shoes. Refer to
“Skid Shoe
Adjustment” on page 17 for detailed instructions.
New Rubber Snow Blade
Refer to Figure 3-2:
The new rubber snow blade (#4) should be adjusted
down until the leading edge is even with bottom of skid
shoes.
1. Complete “Preparation” above.
2. Loosen all hex whiz nuts (#3) and raise snow
blade (#4) until leading edge of snow blade is even
with bottom of skid shoe.
3. Tighten hex whiz nuts (#3).
4. Back drag unit 50 yards on dry concrete to level
trailing edge of snow blade with bottom of skid shoe.
Worn Rubber Snow Blade Adjustment
Refer to Figure 3-2:
A worn snow blade (#4) can be adjusted down until the
leading edge is even with bottom of skid shoes.
1. Complete “Preparation” above.
2. Loosen all hex whiz nuts (#3) and adjust snow
blade (#4) down until leading edge of snow blade is
even with bottom edge of skid shoe.
3. Tighten hex whiz nuts (#3).
Reverse Rubber Snow Blade
Refer to Figure 3-2:
The snow blade (#5) can be reversed (rotated upside
down) and reused to extend its life. Replace rubber snow
blade when both edges can no longer be adjusted down.
1. Complete “Preparation” on this page.
2. Remove hex whiz nuts (#3), carriage bolts (#2),
blade support bars (#1), and snow blade (#4).
3. Rotate snow blade upside down and reattach with
existing hardware. Do not tighten nuts at this time.
4. Raise snow blade (#4) until leading edge of snow
blade is even with bottom of skid shoes. Tighten hex
whiz nuts (#3).
5. Back drag unit 50 yards on dry concrete to level
trailing edge of snow blade with bottom of skid shoe.
Rubber Snow Blade Adjustment & Reversing
Figure 3-2
TOP HOLE
2ND HOLE
3RD HOLE
4TH HOLE
SKID SHOE MUST BE MOUNTED IN
2ND HOLE FOR SSP15 SERIES &
3RD HOLE FOR SSP25 SERIES
LEADING EDGE OF SNOW
BLADE MUST BE SET EVEN
WITH BOTTOM OF SKID SHOE
37038