Land Pride SPL05 Series, Руководство оператора

Страница: 26 / 34

Section 3: Maintenance
SPL0548 & SPL0560 Snow Pusher 303-454M 11/9/20
22
Table of Contents
Maintenance
Proper servicing and adjustment are key to the long life of
any attachment. With careful inspection and routine
maintenance, you can avoid costly downtime and repair.
Check all bolts after using the unit for several hours to be
sure they are tight. Replace any worn, damaged, or
illegible safety labels by obtaining new labels from your
nearest Land Pride dealer.
The parts on your Snow Pusher have been specially
designed and should only be replaced with genuine Land
Pride parts. Do not alter the Snow Pusher in a way which
will adversely affect its performance.
DANGER
!
To avoid serious injury or death: Do not go near or under
raised loader arms without first securing loader arms in the
raised position with an approved lift-arm support.
WARNING
!
To avoid serious injury or death:
•
Perform scheduled maintenance. Check for loose
hardware, missing parts, broken parts, structural cracks,
and excessive wear. Make repairs before putting the
implement back into service.
•
Allow only persons to perform maintenance on this
attachment who have been properly trained in the safe
operation of this attachment.
•
Before making adjustments, lower attachment to the
ground, shut engine off, and remove ignition key. Do not
attempt to make adjustments with attachment or power
machine running.
•
Always secure equipment with solid, non-concrete supports
before working under it. Never go under equipment
supported by concrete blocks or hydraulics. Concrete can
break, hydraulic lines can burst, and/or hydraulic controls
can be actuated even when power to hydraulics is off.
•
Do not alter implement or replace parts on the implement
with other brands. Other brands may not fit properly or
meet OEM (Original Equipment Manufacturer)
specifications. They can weaken the integrity and impair the
safety, function, performance, and life of the implement.
Replace parts only with genuine OEM parts.
Skid Shoe Replacement
Figure 3-1
Skid Shoes
Refer to Figure 3-1:
The skid shoes are 3/8" (10 mm) thick when new and
should be replaced before they are worn through.
WARNING
!
To avoid serious injury or death:
•
Perform maintenance to the Snow Pusher with unit hooked
to the loader arms. An unhooked Snow Pusher can tip over
backwards causing serious injury or death.
•
Always secure equipment with solid, non-concrete supports
before working under it. Never go under equipment
supported by concrete blocks or hydraulics. Concrete can
break, hydraulic lines can burst, and/or hydraulic controls
can be actuated even when power to hydraulics is off.
1. Park tractor with attached Snow Pusher on level
ground.
2. Lower Snow Pusher until blade is resting
4" to 6" (10 cm to 15 cm) off the ground on support
blocks (#4).
3. Shut tractor down properly before dismounting to
adjust skid shoes. Refer to “Tractor Shutdown
Procedure”
on page 21.
4. On the left-hand side, remove hex whiz nuts (#3),
plow bolts (#2), and skid shoe (#1).
5. Repeat step 4 for the right-hand side.
6. Reattach new skid shoes to the left and right-hand
sides with existing 3/8"-16 x 1" GR5 plow bolts (#2)
and hex whiz nuts (#3). Tighten hex whiz nuts to the
correct torque.
39719
Section 3: Maintenance